TCI Premium 2K Urethane Primer Surfacer w/Activator
$ 95.05
- Description TCI 2K High Build Urethane Primer Surfacer 4200 | Gray – 4.4 VOC (1 Gallon/3.785 Liters) Included with purchase 422/421 | TCI Activator – 4.4 VOC PRODUCT DESCRIPTION: TCI Premium Gray 2K High Build Urethane Primer is formulated for maximum holdout and minimal sand-scratch swelling. Dries fast and builds quickly. TECHNICAL DATA: Color: Gray Mixing Ratio: 4:1:1 Catalyst: #422/421 Activator 1.5mm – 2.2mmm for Conventional and HVLP guns 35-45 psi at the gun for Conventional gun 28-35 psi at the gun for HVLP gun Film Build : 3.0 mils wet Pot Life: 3 hours VOC: 4.4 lbs/gallon (RTS) TCI 4200- Technical Information Sheet DESCRIPTION: 4200 Premium 2K Urethane Primer 4200 is a two component acrylic urethane primer designed to provide ease of sanding as well as exceptional adhesion, film build, and cure time. INSTRUCTIONS: Sand original finish with medium grit sandpaper Clean all area with wax and grease remover Surface should be clean and dry before applying product Spray two or three medium coats of 4200, allowing each coat to flash to a dull appearance before applying the next coat. For best results force dry or allow to air dry for one hour before sanding 4200 can be block or machine sanded with P320 or P400, or wet sanded with P400 or P500 grit before applying topcoat GENERAL: Appearance -Gray Liquid Viscosity -Full Bodied Shelf Life -One Year (unopened) VOC -3.74 lb/gal (448 g/L) Pot Life -30 – 60 Minutes @ 75˚ F Product size – Primer – 4200 -One gallon or quart cans – Activator – 422 – Cone top quart or half pint cans PRODUCT MIXING: Thoroughly mix four parts 4200 with one part of 422 activator May be reduced 4:1:1 with urethane reducer if a lower viscosity is desired SUBSTRATES: Coat large bare metal, steel & aluminum areas with proper self-etching sealer Recommended substrate temperatures: 50˚ F – 100˚ F. GUN SET-UP TIP AIR PRESSURE Siphon Feed 1.8 – 2.0 mm 30 – 40 psi Gravity Feed 1.6 – 2.0 mm 25 – 40 psi HVLP (gravity) 1.6 – 2.0 mm 6 – 10 psi GUN CLEAN-UP: Clean equipment with a high quality lacquer thinner immediately after spraying TECHNICAL INFO: For additional technical information call (800-824-4999) SAFETY DATA: Refer to SDS for 4200 and 422 FOR INDUSTRIAL USE ONLY. TO PROTECT AGAINST HARMFUL VAPOR & SPRAY WEAR A POSITIVE – PRESSURE SUPPLIED AIR RESPIRATOR (NIOSH APPROVED), EYEPROTECTION, GLOVES AND PROTECTIVE CLOTHING WHILE MIXING AND SPRAYING. FOLLOW SDS FOR APPROPRIATE SAFETY AND HEALTH INSTRUCTIONS DISCLAIMER: The information contained on this Technical Data Sheet is intended to assist you in product application. It is based on knowledge of general industry use, experience & research. Since conditions of storage, handling, and product use are not under our control,buyers must assume responsibility for suitability of the product for their specific purposes.
Premium Gold Body Filler (5064)
XTREME Original Klearkote 4.4 VOC
Paintforcars Starfire Acrylic Enamel Clear Coat – 1 Gal.
5 Star Original Hardener